Mtd 249-645A Manual do Utilizador descarregar pdf (Página 9)

10W30

OIL

H.D.

FUNNEL

BREATHER

TUBE

FIGURE 16

Before starting engine:

During initial break-in period, oil level should be

watched closely. See ENGINE MAINTENANCE.

Use MS classification oil. Do not use oils marked

only MM or ML or unmarked.

Above 32° use SAE 30; below 32° use SAE 10W.

These recommendations must be followed for best

performance and long life.

Change oil first two (2) hours of operation and

check qil level every five (5) operating hours or

each time equipment is used.

Change oil every twenty-five (25) operating hours

or sooner if equipment is operated in extremely

dusty or dirty conditions.

LOG SPLITTER:

The oil in the reservoir should be changed every (100)

hours of operation.

NOTE

Carburetors are preset at the factory.

DO NOT attempt to make adjustments

at this time. See carburetor

instructions outlined under CAR

BURETOR ADJUSTMENT in Engine

Manual.

The' ram should take approximately 30 seconds to

make a complete cycle. This speed may vary

depending on throttle setting and temperature of oil.

TO START ENGINE

1. Place throttle control lever (on beam) in run

position. See figure 17.

2. Move choke lever to CHOKE position. See

figure 18.

THROTTLE CONTROL

FIGURE 17

FIGURE 18

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sem comentários

Mtd 249-645A Manual do Utilizador Página 9