MTD E6C3H Manual do Operador descarregar pdf (Página 12)

wheel hub.This position gives power drive to the left

wheel only, making the unit easier to maneuver.

BothWheelsDriving

• Rotate wheel assembly to align hole in the hub with

the inner hole on the axle shaft. Insert klick pin in

the hole. Outer axle shaft hole should be visible.

IMPORTANT:NEVER operate the snow thrower with the

click pin inserted through both the RIM and the

OUTSIDE HOLE in the axle. Doing so can result in

serious damage to the drive system.

Inside Hole

Axle

Pin In

Outside Hole

Figure 11

SECTION6: MAINTAININGYOURSNOWTHROWER

WARNING: Before lubricating, repairing, or

inspecting, disengage all clutch levers and

stop engine. Wait until all moving parts have

come to a complete stop. Disconnect spark

plug wire and ground it against the engine to

prevent unintended starting.

Lubrication

Engine

Refer to the separate engine manual packed with your

unit for all engine lubrication instructions.

,_ WARNING: If any adjustments need to be

made to the engine while the engine is

running (e.g. carburetor), keep clear of all

moving parts. Be careful of muffler, engine

and other surrounding heated surfaces.

Wheels

Oil or spray lubricant into bearings at wheels at

least once a season. Pull klick pin, remove wheels,

clean and coat axles with a multipurpose

automotive grease. See Figure 12.

(_ ............ Klick Pin

Figure 12

ChuteDirectionalControl

• The worm gear on the chute directional control

should be greased with multipurpose automotive

grease.

GearShaft

Lubricate the gear shaft with 6-n-1 grease at least once

a season or after every 25 hours of operation (available

at automotive stores, or order part number 737-0170).

Refer to Figure 8.

IMPORTANT: Keep all grease and oil off of the rubber

friction wheel and aluminum drive plate.

GearCase

The gear case is lubricated with grease at the factory

and it does not require checking. If disassembled for

any reason, lubricate with 2 ounces of Shell Alvania

grease EPR00, part number 737-0168.

IMPORTANT: Do not overfill the gear case, since

damage to the seals could result. Be sure the vent plug

is free of grease in order to relieve pressure.

See Figure 13.

AugerShaft

At least once a season, remove the shear bolts on the

auger shaft. Spray lubricant inside the shaft and

lubricate the plastic auger bearings at least once a

season. See Figure 13.

Vent Plug

Plastic Plastic

Bearing Shear Bolts Bearing

Figure 13

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comentários a estes Manuais

Sem comentários

MTD E6C3H Manual do Operador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Sopradores de neve MTD E6C3H