MTD E600E Manual do Operador descarregar pdf (Página 8)

AttachingTheChuteAssembly

(HardwareC)

Place chute assembly over chute opening, with the

opening in the chute assembly facing the front of the

unit. Place chute flange keepers beneath lipof chute

assembly, with the fiat side down. Secure with hex

bolts and hex lock nuts. Tighten with two adjustable

wrenches. Do not overtighten. See Figure 5.

Chute

Figure 5

AttachingTheChuteDirectionalControl

(HardwareD)

Thread one hex nut about halfway onto eye bolt on

the chute directional control. Insert eye bolt

through the hole provided in the left handle. See

Figure 6.

Secure with cupped washer (cupped side against

the handle) and other hex nut. Do not tighten until

after attaching the other end of the chute

directional control.

Cupped

Hex Nut

e Bolt

Figure 6

To align the spiral on the chute directional control,

it may be necessary to loosen the carriage bolts

and hex lock nuts which secure the lower chute

bracket to the extension on the leftside of the

chute assembly. See Figure 7.

Carriage

Hex Lock

Nuts

Bracket

Figure 7

Place one flat washer on the end of the chute

directional control, then insert the end of the

control into the hole in the plastic bushing in the

lower chute bracket. Place another flat washer on

the end of the chute directional control, and insert

hairpin clip into hole in the end of control. See

Figure 8.

Hairpin

Flat _'_

Washers

Chute

L /(_irne_:tiro_nal

_Lower Chute

Bracket

Figure 8

Adjust the chute bracket so that the spiral on the

chute directional control fully engages the teeth on

the chute assembly. Tighten the nuts on the lower

chute bracket securely. Tighten the hex nut on the

eye bolt on the chute directional control.

IMPORTANT: Attach the shift rod and clutch cables as

follows. THEN CHECK THE ADJUSTMENTS AS

INSTRUCTED, AND MAKE ANY FINAL

ADJUSTMENTS NECESSARY BEFORE

OPERATING YOUR SNOW THROWER. Failure to

follow the instructions may cause damage to the snow

thrower.

AttachingTheShiftRod(HardwareB)

Place the shift lever (on the handle panel) in the

sixth (6) speed position (all the way forward).

Place the bent end of the shift rod into the hole in

the shift arm assembly. Secure with flat washer

and hairpin clip. See Figure 9.

Start threading the ferrule onto the other end of the

shift rod. Push down on the shift rod (and shift arm

assembly) as far as it wilt go.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comentários a estes Manuais

Sem comentários

MTD E600E Manual do Operador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Sopradores de neve MTD E600E