MTD E600E Manual do Operador descarregar pdf (Página 10)

Carriagd

Bolts kid

.......... __,_Shoes

Figure 11

It is not recommended that you operate this snow

thrower on gravel as loose gravel can be easily picked

up and thrown by the auger causing an injury or

damage to the snow thrower.

TirePressure(PneumaticTires)

The tires are over-inflated for shipping purposes.

Check tire pressure and reduce to 15 to 20 psi.

NOTE: If the tire pressure is not equal in both tires,

the unit may pull to one side or the other.

SECTION4: KNOWYOURSNOWTHROWER

WARNING: Be familiar with all controls

and their proper operation. Know how to

stop the machine and disengage them

quickly.

OperatingControls

Auger Traction / Auger

Control Control Lock

Directional

Control

• AUGERCONTROL

CHUTE OIR_CTIONAL CONTROL

F 11

R21m

CLOC_SE TOD_SC_AR_ELEFT

_OU_TERCLOCK_SE TOD_SC_RGER_G_T

Figure 12

Shift Lever

The shift lever is located in the center of the handle

panel. The shift lever may be moved into one of eight

positions. Run engine with throttle in the fast position.

Use the shift lever to determine ground speed.

See Figure 12.

Forward - There are six speeds. Position number one

(1) is the slowest. Position number six (6) is the

fastest.

Reverse - There are two reverse (R) speeds R1 and

R2. The "R2" closest to the operator (ait the way back)

is the faster of the two.

AugerControl

The auger control is located on the left handle.

Squeeze the control to engage the augers. Release to

stop the snow throwing action. (Traction control must

also be released.) See Figure 12.

Traction/ AugerControlLock

The traction control is located on the right handle.

Squeeze the control to engage the wheel drive.

Release to stop.

This same control also locks the auger control so you

can turn the chute directional control without

interrupting the snow throwing process. If the auger

control is engaged with the traction control engaged,

the operator can release the auger control (on the left

handle) and the augers will remain engaged. Release

the traction control to stop both the augers and wheel

drive (auger control must also be released).

See Figure 12.

ChuteDirectionalControl

The chute directional control is located on left hand

side of the snow thrower. See Figure 12.

To change the direction in which snow is thrown, turn

chute directional control as follows:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comentários a estes Manuais

Sem comentários

MTD E600E Manual do Operador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Sopradores de neve MTD E600E