MTD 737-0168 Manual do Operador descarregar pdf (Página 8)

Coupler

Spring

Cable

\ \ \

Lock Nut

Figure 10

Tire Pressure (PneumaticTires)

The tires are overinflated for shipping purposes.

• Check tire pressure. Maintain pressure between 10

and 14 psi.

NOTE: If the tire pressure is not equal in all tires, the

unit may pull to one side or the other.

_ WARNING: Maximum tire pressure under

any circumstance is 30 psi. Equal tire pressure

should be maintained at all times. Excessive

pressure (over 30 psi) when seating beads

may cause tire/rim assembly to burst with force

sufficient to cause serious injury.

SECTION3: KNOWINGYOURSNOWTHROWER

_ ARNING" Be familiar with all the controls on the snow thrower and their proper operation. Know how tostop the machine and disengage them quickly.

Compare the Figure below with your equipment and be familiar with its controls before starting it.

Headlight

Wheel DriveControl/ / Shift Lever

Auger Control Lock //- Chute Tilt Control

Fuel Tank ,\ Auger Drive Control

Oil Fill \

Discharge Chute

Chute Crank

Chute Clean-Out Tool_

\ _ Wheel Steering

\ Control

Auger --_ Skid Shoe

Figure 11

Drive Control/ AugerControlLock

The drive control is located on the right handle.

Squeeze the drive control to engage the wheel drive.

Release to stop.

This same lever also locks the auger control so you can

operate the chute crank without interrupting the snow

throwing process. If the auger control is engaged

simultaneously with the drive control, the operator can

release the auger control (on the left handle) and the

augers will remain engaged. Release the drive control

to stop the augers and wheel drive (the auger control

must also be released).

IMPORTANT: Always release the drive control before

changing speeds.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Comentários a estes Manuais

Sem comentários

MTD 737-0168 Manual do Operador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Sopradores de neve MTD 737-0168