MTD 600 SERIES Manual do Operador descarregar pdf (Página 11)

Place chute assembly onto chute base and secure chute

control assembly to chute support bracket with clevis pin

and cotter pin removed earlier. See Fig. 3-13.

4. Insert the chute directional control rod into the support

bracket on the rear of the dash panel. See Fig. 3-15.

Figure 3-13

Finish securing chute control assembly to chute support

bracket with wing nut and hex screw removed earlier.

See Fig. 3-14.

Figure 3-14

Figure 3-15

Remove the hairpin clip from the rear of the chute control

assembly. See Fig 3-16.

Figure 3-16

6_ Secure the chute directional control rod to the chute

control assembly with the hairpin clip removed earlier.

See Fig 3-16.

SECTION3 -- ASSEMBLY& SET-UP 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sem comentários

MTD 600 SERIES Manual do Operador Página 11