MTD 490-241-0032 Manual do Operador descarregar pdf (Página 12)

12 Section 3— ASSembly & Set-Up

3. Finish securing chute control assembly to chute support

bracket with wing nut and hex screw removed earlier.

See Figure 3-14.

Figure 3-14

4. Insert the chute directional control rod into the support

bracket on the rear of the dash panel. See Figure 3-15.

Figure 3-15

5. Remove the hairpin clip from the rear of the chute control

assembly. See Figure 3-16a.

6. Insert chute directional control rod into rear of the chute

control assembly. See Figure 3-16b. Secure the chute

directional control rod to the chute control assembly with

the hairpin clip removed earlier.

Figure 3-16

Standard Crank Assembly

Handle

1. Place the shift lever in the forward-6 position (if equipped).

2. Observe the lower rear area of the snow thrower to be sure

both cables are aligned with roller guides before pivoting

the handle upward. See Figure 3-17.

Figure 3-17

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sem comentários

MTD 490-241-0032 Manual do Operador Página 12