MTD 030 Series Manual do Operador descarregar pdf (Página 13)

Controlsand Features

Recoil Starter

Cutting Height

Adjustment

Lever (One at

each wheel)

Figure 4-1

BladeControl

The blade control is attached to the upper handle of the mower.

Depress and squeeze it against the upper handle to operate the

unit. Release it to stop engine and blade.

_ ARNING: This blade control is a safety device.

Never attempt to bypass its operations.

Cutting HeightAdjustmentLever

One adjustment lever is located on each wheel and is used to

adjust the cutting height. All four levers have to be at the same

relative position to ensure a uniform cut. To adjust the cutting

height, refer to the "Assembly & Set-Up" Section.

RecoilStarter

The recoil starter is attached to the right upper handle. Stand

behind the unit and pull the recoil starter rope to start the unit.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

MTD 030 Series Manual do Operador Página 13