MTD TP720r Manual do Operador descarregar pdf (Página 11)

OPERATING THE EZ-LINK TM SYSTEM

The EZ-Link TM system enables the use of these optional

Add-Ons:

Blower/Vacuum .......................... BV720r

Cultivator .............................. GC720r

Edger .................................. LE720r

Hedge Trimmer .......................... HS720r

Snow Thrower ........................... ST720r

Straight Shaft Trimmer .................... SS725r

Tree Pruner ............................. TP720r

Turbo Blower ............................ TB720r

WARNING:Read and understand the I

operator's manual for each add:on prior to I

operation.

Removing the Cutting Attachment or Add-Ons

1. Turn the knob counterclockwise to loosen (Fig. 10).

2. Press and hold the release button (Fig. 10).

3. While firmly holding the upper shaft housing, pull

the cutting attachment or add-on straight out of the

EZ-LinM M coupler (Fig. 11).

WARNING: To avoid serious personal injury I

and damage to the unit, shut off the unit

before removing or installing add,ons. ]

Installing the Cutting Attachment or Add-On

NOTE: Place the unit on the ground or on a work bench

to make add-on installation or removal easier.

1. Turn knob counterclockwise to loosen.

2. While firmly holding the add-on, push it straight into

the EZ-LinM M coupler (Fig. 11).

NOTE: Aligning the release button with the guide recess

will help installation (Fig. 10).

Release Button

EZ.LinkTM Coupler Hole

Fig. 11

Turn the knob clockwise to tighten (Fig. 12).

CAUTION: Lock the release button in the

primary hole and securely tighten the knob

before operat ng th sun t J

90° Edging Hole _-_

(Trimmer Only)

180°EdgingHole

(Trimmer Only)

Fig. 12

Guide Recess

Fig. 10

CAUTION: The cutting attachment and add-

ons with the EZ-Link TM system are to be used in

the primary hole unless stated otherwise in the

specific add-ons operator's manual. Using the

wrong hole could lead to personal injury or

damage to the unit.

For edging (when using the line head cutting attachment

with EZ-Link TM models), lock the release button of the

cutting attachment into the 90° edging hole or the 180°

edging hole (Fig. 12).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comentários a estes Manuais

Sem comentários

MTD TP720r Manual do Operador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Roçadora corta-relva MTD TP720r