MTD hs720r Manual do Operador descarregar pdf (Página 12)

OPERATING THE EZ-LINK TM SYSTEM

The EZ-Link TM system enables the use of these optional

Add-Ons,

Blower/Vacuum .......................... BV720r

Cultivator .............................. GC720r

Edger .................................. LE720r

Hedge Trimmer .......................... HS720r

Snow Thrower ........................... ST720r

Straight Shaft Trimmer .................... SS725r

Tree Pruner ............................. TP720r

Turbo Blower ............................ TB720r

WARNING: Read and understand the

operator's manual for each add-on prior to

operation,

Removing the Cutting Attachment or Add-Ons

1. Turn the knob counterclockwise to loosen (Fig. 14).

2. Press and hold the release button (Fig, 14).

3. While firmly holding the upper shaft housing, pull

the cutting attachment or add-on straight out of the

EZ-Link TM coupler (Fig. 15).

WARNING: To avoid serious personal injury

and damage to the unit, shut unit off before

removing or installing add-ons.

Installing the Cutting Attachment or Add-Ons

NOTE: To make installing or removing the add-on

easier, place the unit on the ground or on a work

bench.

1. Turn knob counterclockwise to loosen (Fig. 14).

EZ-LinW M Coupler

Release Button

Knob

Fig. 14

Guide Recess

2. While firmly holding the add-on, push it straight into

the EZ-LinM M coupler (Fig. 15).

NOTE: Aligning the release button with the guide recess

will help installation (Fig. 14).

Release Button

EZ-Link TM Coupler

Primary Hole

Upper Shaft Housing

Lower Shaft Housing

Fig. 15

3. Turn the knob clockwise to tighten (Fig. 16).

_i CAUTION: Lock the release button in the

primary hole and securely tighten the knob

before operat ng th sun t.

90 Edging Hole / \

"\_//

180" Edging Hole

Fig. 16

CAUTION: The cutting attachment and

add-ons with the EZ-Link TM system are to be

used in the primary hole unless stated

otherwise in the specific add-ons operator's

manual, Using the wrong hole could lead to

personal injury, or damage to the unit,

For edging when using the line head cutting attachment

with EZ-Link rM models, lock the release button of the

cutting attachment into the 90 ° edging hole or the 180°

edging hole (Fig. 16).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Comentários a estes Manuais

Sem comentários

MTD hs720r Manual do Operador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Roçadora corta-relva MTD hs720r