MTD 70 Series Especificações descarregar pdf (Página 49)

STARTER AND CHARGING SYSTEMS

Recoil Starter Removal

To remove recoil assembly from the engine:

1. Remove the three nuts that secure the recoil

assembly to the engine using a 8mm wrench.

See Figure 6.1.

2. Install the starter by following the above step in

reverse order. Tighten the screws to a torque of

53 - 71 in-lbs (6-8 Nm).

Figure 6.1

Remove these screws

Starter Cup

The starter cup is a steel cup that is bolted to the fly-

wheel.

1. Inspect the inside of the starter cup. See Figure

6.2.

NOTE: If the starter was failing to engage the fly-

wheel, and the edges of the teeth inside the cup

are burred or damaged, replace the starter cup.

NOTE: If the starter cup is replaced, the com-

plete starter should be replaced as well, to pre-

vent a repeat failure.

2. Remove the starter cup by removing the fly-

wheel nut.

Figure 6.2

Starter cup

Inspect slots

CHAPTER 6: STARTER AND CHARGING SYSTEMS

www.mymowerparts.com

For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 88 89

Sem comentários

MTD 70 Series Especificações Página 49