MTD RZT Series Manual do Operador descarregar pdf (Página 9)

9se c t i O n 2 — as s e M b l y & se t -up

reposition the other control lever in approximately the

same position.

Figure 3-3

5. Adjusting Drive Control Levers” in Maintenance

& Adjustments for instructions on final adjustment of

the levers.

Position Rear Bumper (If Equipped)

Some models are equipped with a rear bumber. For ship-

ping purposes the rear bumper is rotated upward from its

normal position. To reposition the rear bumper, refer to

Figure 3 and proceed as follows:

From inside the tractor frame, just behind the rear 1.

tires, remove the internal cotter pins from the clevis

pins securing the bumper to each side of the frame.

While supporting the rear bumper, cut the cable tie 2.

fastening the bumper to the engine lift bracket, and

remove the clevis pins from each side. See Figure 3-4.

Figure 3-4

Remove the bumper and reposition to align the notch 3.

at each end of the bumper with the spacer on each

side of the frame. Slide the bumper notches onto the

spacers. Refer to Figure 3-4.

Connect the Battery

WARNING!: 

related accessories contain lead and lead

compounds. Wash hands after handling.

The tractor is shipped with an activated sealed battery,

with the positive battery cable factory connected. The

negative cable must be connected.

NOTE: Make sure the ignition switch is in the “OFF” position

before attaching the battery cable.

1.

terminal of the battery, and remove the hex cap screw

and nut from the free end of the negative battery

cable.

Connect the negative battery cable (heavy black) to 2.



cap screw and nut. Slide the black terminal cover over

the negative terminal of the battery.

Mulching Plug (If Provided) and Shipping Brace Removal

WARNING!: Never operate the mower deck

without the chute deflector installed and in the

down position.

Mulching Plug (If Provided)

Some models equipped with a 50" mowing deck also have

a mulching plug provided. If your tractor is equipped with

a mulching plug, remove the plug as follows:

Fully raise the chute deflector so that the locking tabs 

at the the top of the mulching plug are free of the

deflector; then slide the mulching plug out of the deck

discharge opening. Lower the chute deflector.

Check the mower deck for a shipping brace (w/tag) that

may be holding the chute deflector upward for shipment.

If a brace is present, it must be removed before operating



remove the shipping by grasping it and rotating it

clockwise. Lower the chute deflector. See Figure 3-5.

Figure 3-5

Spacer

Clevis Pin

Internal

Cotter Pin

Notch



Lift Control

Lever Upward

Control Lever

Flange

Lock Nut

Pivot

Bracket

Hex

Slotted

Hole

Washer

Screw

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comentários a estes Manuais

Sem comentários

MTD RZT Series Manual do Operador Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Trator MTD RZT Series