Mtd 556 Manual do Utilizador descarregar pdf (Página 11)

Control!

Handle!

Splitting

Wedge

End Plate

Reservoir Tank

FIGURE 16.—Horizontal Position

TO OPERATE LOG SPLITTER:

WARNING: Wear leather work gloves,

safety shoes and safety glasses when

operating log splitter. Ensure safe footing.

1. Place the log splitter on level dry solid ground.

2. Place the beam in either the horizontal or vertical

position and lock in place with the appropriate

locking rod. See figure 7 or 13.

3. Place a chock (block) in front and back of both

wheels.

4. Set the engine throttle at maximum speed.

5. Place the log against the end plate. Only split

wood in the direction of the grain.

6. When necessary to stabilize the log, place your

hand only on sides of log, NEVER on the end

between the log and splitting wedge.

7. ONLY ONE ADULT SHOULD STABILIZE THE

LOG AND OPERATE THE CONTROL HANDLE

so the operator has full control over stabilizing the

log and movement of the splitting wedge.

8. Operating Positions:

• Vertical—Stand in front of the log splitter. Oper

ate the control handle with your right hand and

stabilize the log, if necessary, with your left

hand. See figure 15.

• Horizontal—Stand behind the reservoir tank.

Operate the control handle with your right hand

and stabilize the log, if necessary, with your left

hand. See figure 16.

9. Move the control handle into the FORWARD (split

ting) position.

10. Relese the control handle to stop the wedge

movement.

11. Move the control handle to the REVERSE position

to return the wedge.

WARNING: If the fluid becomes exces

sively hot at any time during operation,

stop the unit and aiiow the fiuid to cooi

down. Maximum performance wiil not be

obtained from your log splitter if the fluid

is too hot. Use extreme caution as con

tacting hot fluid could result in serious

personal injury.

TO TRANSPORT LOG SPLITTER

1. Lower the beam to its horizontal position. Make

certain the beam is latched securely with the lock

ing rod.

2. Remove the quick release pin which secures the

jack stand. Support the tongue, and pivot the jack

stand up against the tongue. Secure with the

quick release pin.

3. Attach the hitch to a towing vehicle, making

certain to latch securely. Attach the safety chains

to the towing vehicle.

ADJUSTMENTS

WARNING: Always stop the engine and

disconnect the spark plug wire before

performing any adjustments.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentários a estes Manuais

Sem comentários

Mtd 556 Manual do Utilizador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Mtd 556