Mtd 249-623-003 Manual do Utilizador descarregar pdf (Página 13)

NOTE

Make certain proper clearance is ob

tained before tightening set screw.

PUMP

TIRE PRESSURE

Check sidewall of tire for manufacturer’s recommended

maximum tire pressure. If this information does not ap

pear on your tire, maximum tire pressure under any cir

cumstances is 30 p.s.i. Equal pressure should be

maintained on both tires.

INSTALLATION OF TIRE TO RIM

i WARNING i

^ ^ ^ ^ ^ ^

The following procedure must be fol

lowed when removing or installing a

tire to the rim.

1. Be certain rim is clean and free of rust.

2. Lubricate both the tire and rim generously.

3. Never inflate to over 30 p.s.i. to seat beads. Ex

cessive pressure when seating beads may cause

tire/rim assembly to burst with force sufficient to

cause serious injury.

OFF-SEASON STORAGE

To avoid engine problems, the fuel system should be

emptied before storage of 30 days or longer. Follow

these instructions.

1. Drain the fuel tank. Start the engine, and let it run

until the fuel lines and carburetor are empty.

Ì WARNING t

DO NOT DRAIN FUEL WHILE

SMOKING, OR IF NEAR AN OPEN FIRE.

2. Drain all the oil from the crankcase (this should be

done after the engine has been operated and is

still warm) and refill the crankcase with fresh oil.

3. Protect the inside of the engine for storage as

follows.

Remove spark plug, pour approximately V2 ounce

(approximately one tablespoon) of engine oil into

cylinder and crank slowly to distribute oil. Replace

spark plug.

4. Clean the engine and the entire log splitter

thoroughly.

5. Wipe unit with an oiled rag to prevent rust,

especially wedge and beam.

NOTE

When storing any type of power

equipment in an unventilated or metal

storage shed, care should be taken to

rustproof the equipment by coating with

a light oil or silicone.

6. The tongue can be removed and reattached in an

upright position as shown in figure 18 to take less

space when storing.

7. Store unit in a clean, dry area.

FIGURE 18.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Comentários a estes Manuais

Sem comentários

Mtd 249-623-003 Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Mtd 249-623-003