Mtd 242A641-000 Manual do Utilizador

$1.00V,OWNEirS GUIDE• ASSEMBLY • OPERATION • MAINTENANCE • PARTS •Important:Read Safety Rules and Instructions Carefully3.5and4H.P.SHREDDERSModel Num

242-640, 242A640 242-641, 242A641NOTEThis instruction manuai covers various modeis, and ail specifications shown do not necessarily apply

242-640/242A640 L242-6415\!242A641PARTS LIST FOR SHREDDERSREF.NO.PARTNO.CODE DESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1742-0571 NBladet28 736-0242 Bell

ALOOK FOR THIS SYMBOL TO POINT OUT IMPCRTANT SAFETY PRECAUTIONS. IT MEAMS-ATTENTION!!! BECOME ALERT!!! YOUF SAFETY IS INVOLVED.FOR REPLA CE

S/.FETY RULESAWARNING: TO REDUCE THE POTENTIAL FOR ANY INJURY, COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS. FAILURE TO COMPLY WITH THE INSTRUCTIONS

ASSEMBLY INSTRUCTIONSIMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After assembly, see separate engine manual for proper fuel an

OPERATIONKNOW YOUR SHREDDERREAD THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR SHREDDER. Compare the illustrations with your

X.Throttle ControlVStarterHandleFIGURE 5.2. Move choke lever to CHOKE position (a warm engine may not require choking).3. Grasp starter han

IMPORTANT: There is a flail screen located inside the housing in the discharge area. If the flai screen becomes clogged, remove and

VSHARPENING OR REPLACING CHIPPER BLADES1. Disconnect spark plug wire and move it away from spark plug.2. Remove the flail screen as inst

When reassembling the blade, tighten to betwc en 550 and 650 inch pounds, or lacking torque wrenci, tighten securely.FLAILSThe flail

TROUBLE SHOOTINGPROBLEMPOSSIBLE CAUSE(S)CORRECTIVE ACTIONEngine fails to start 1. Fuel tank empty, or stale fuel.2. Spark plug wire disconnected.3.