MTD 570 Series Manual do Utilizador descarregar pdf (Página 12)

2.6 Installation location

Under-sink installation

The appliance should be installed according to choice as an under-sink unit‘ in a closed, frost free room in the

vincinity of a water draw off point.

Dismantled unit is to be stored in a frost-free place, as residual water always remains in the unit.

2.7 Unit installation

Loosen cover securing screws by two turns.

Using a screwdriver, release the snap closing catch.

Take off the unit front cover with heating block.

Fix the unit rear panel to the wall using dowels and screws; use the unit rear panel as a drilling template.

Hook on the unit front panel with heating block.

Engage the heating block in the snap closing catch.

Secure the unit front cover with 2 screws.

2.8 Tap installation

screw T-piece on angle valve

screw cold water connection on to T-piece

screw connection hose (13) on to the T-piece

screw the free end of connection hose (13) on to the cold water inlet of the MTD, while doing this, you must

hold the connection piece of the unit in position with a 14 mm spanner to avoid any damage

screw the warm-water-pipe of the tap-ﬁtting on to the units warm water outlet ﬁtting, while doing this, you

must hold the connection piece of the unit in position with a 14 mm spanner.

2.9 Electrical connection

The unit must be connected to the protective earth terminal.

This appliance is ﬁtted with a power supply cable.

The units are ﬁtted with an electric cable for a ﬁxed electrical installation

The elctrical ﬁxed connection may be performed with a diamater for the wire of 3 times 6 mm².

2.10 First start-up (may only be carried out by a qualiﬁed installer)

26_02_02_0656

Fill and deaerate the unit.

Note: danger of running dry!

Open and close the tap repeatedly until the pipework and the

unit are free of air. For guidance on air, see „2.2 Important

information“.

Switch on the mains power.

Test the operating mode of the instantaneous water hea-

ter and armature.

Handover of the unit

Explain the function of the unit to the user and familiarize him or her with its use.

Draw the user’s attention to possible hazards (scalding).

Hand over these instructions for careful retention.

2.11 Special accessories

Jet regulator „SR“ for use in the jet-regulator screw ﬁtting M22/M24.

MTD 350 / MTD 440:

SR 3 order no: 14 35 02 with output regulator.

MTD 570:

SR 5 order no. 27 05 82

for the qualiﬁed installer

272867-34655-0751 MTD 350 - 570.12 12 30.01.2008 16:19:50

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comentários a estes Manuais

Sem comentários

MTD 570 Series Manual do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Rachadores de lenha MTD 570 Series