MTD VB20 series Manual do Operador descarregar pdf (Página 15)

Maintenance & Adjustments

Maintenance

General Recommendations

Always observe safety rules when performing any •

maintenance.

The warranty on this lawn mower does not cover items that •

have been subjected to operator abuse or negligence. To

receive full value from warranty, operator must maintain

the lawn mower as instructed here.

Changing of engine-governed speed will void engine •

warranty.

All adjustments should be checked at least once each •

season.

Periodically check all fasteners and make sure these are •

tight.

WARNING: Always stop engine, disconnect spark

plug, and ground against engine before performing

any type of maintenance on your machine.

Lubrication

Lubricate pivot points on the blade control at least once 1.

a season with light oil. This control must operate freely in

both directions. See Fig. 6-1.

The transmission is pre-lubricated and sealed at the factory 2.

and does not require lubrication.

Follow the accompanying engine manual for lubrication 3.

schedule and instruction for engine lubrication.

Deck Care

Clean underside of the mower deck after each use to prevent

build-up of grass clippings or other debris. Follow steps below

for this job.

Disconnect spark plug wire. Drain gasoline from lawn 1.

mower or place a piece of plastic under the gas cap.

Tip mower so that it rests on the housing. Keep the side 2.

with the air cleaner facing up. Hold mower firmly.

WARNING: Never tip the mower more than 90º in

any direction and do not leave the mower tipped for

any length of time. Oil can drain into the upper part

of the engine causing a starting problem.

3. Scrape and clean the underside of the deck with a suitable

tool.

4. Put the mower back on its wheels on the ground. If you had

put plastic under the gas cap earlier, make sure to remove it

now.

Figure 6-1

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comentários a estes Manuais

Sem comentários

MTD VB20 series Manual do Operador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Corta-relvas MTD VB20 series