MTD 31A-2M1A731 Manual do Operador descarregar pdf (Página 16)

Adjustments

DO NOT make any engine adjustments. Factory settings are

satisfactory for most conditions. If adjustments are needed,

contact your Authorized MTD Servicing Dealer.

Carburetor

If you think you carburetor needs adjusting, see your nearest

Authorized MTD Servicing Dealer. Engine performance should

NOT be affected at altitudes up to 7,000 feet (2,134 meters). For

operation at higher elevations, contact your Authorized MTD

Servicing Dealer

Cleaning the Engine

If the engine has been running, allow it to cool for at least half

an hour before cleaning. Periodically remove dirt build-up from

the engine. Clean around the muffler. Clean with a brush or

compressed air.

NOTE: Do not spray engine with water to clean because water

could contaminate fuel. Using a garden hose or pressure washing

equipment can also force water into the air cleaner or muffler

opening. Water in the air cleaner will soak the paper element,

and water that passes through the element or muffler can enter

the cylinder, causing damage.

Accumulation of debris around muffler

could cause a fire. Inspect and clean before every

use.

Engine Speed

To avoid serious injury or death, DO

NOT modify engine in any way. Tampering with the

governor setting can lead to a runaway engine and

cause it to operate at unsafe speeds. NEVER tamper

with the factory setting of the engine governor.

Running the engine faster than the

speed set at the factory can be dangerous and will



Removing Snow from the Engine

After each use, remove snow from the following areas:

Oil Fill Cap Dipstick

Fuel Fill Cap

Recoil Starter/Flywheel Screen

Linkage

Guards

Spark Plug Connection (if visible).



equipment Operator’s Manual instructions).

NOTE: See the equipment Operator’s Manual instructions

for proper location of fuel fill cap and control lever.

Removing snow will ease operation of the recoil starter 1.

rope and reduce the risk of water contamination when

opening the fuel fill cap.

Transporting Your Engine

NEVER transport this engine inside of

another vehicle or in any enclosed space if there is

any gasoline in the tank. Fuel vapor or spilled fuel

may ignite.

! If there is fuel in the fuel tank, close the

fuel valve, if equipped, and transport the engine

upright in an open vehicle, such as an open trailer or

open bed of a pickup truck.

If you DO NOT have an open vehicle and have to transport

the engine upright in a closed vehicle, follow these steps for

emptying the fuel tank before transporting:

Empty fuel tank by using a commercially available suction 1.

device designed for use with gasoline.

DO NOT pour fuel from the engine or

siphon fuel by mouth.

Drain fuel into an approved red gasoline container, being 2.

careful to avoid spilling.

Run the engine until remaining fuel is consumed. 3.

NEVER leave the engine unattended

when it is running and NEVER run the engine in an

enclosed area.

Storing Your Engine

Short-Term/Seasonal Storage

Clean Engine

If the engine has been running, allow it to cool for at least half an

hour before cleaning.



blower housing. Discard the dirt and debris from the following

areas:

Cooling Fins

Air Intake Screen or Recoil Starter/Flywheel 

Guard Areas

Spark Plug Connection

Levers

Linkage Area

Guards

Carburetor



Removing debris will insure adequate cooling, correct engine

speed and reduce the risk of fire.

NOTE: Do not spray engine with water to clean because water

could contaminate fuel. Using a garden hose or pressure washing

equipment can also force water into the air cleaner or muffler

opening. Water in the air cleaner will soak the paper element,

and water that passes through the element or muffler can enter

the cylinder, causing damage.

16 se c t i O n 6— Ma i n t e n a n c e

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Comentários a estes Manuais

Sem comentários

MTD 31A-2M1A731 Manual do Operador Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de jardinagem MTD 31A-2M1A731