MTD 25cc Especificações descarregar pdf (Página 57)

Engine Assembly

5. Rotate the flywheel so that the magnets are away

from the module.

6. Remove the two screws that secure the ignition mod-

ule to the block using a T-20 torx driver.

See Figure 8.4.

7. Remove the module.

8. Remove the flywheel by applying a sharp blow to the

crankshaft while gently prying upward with a pry bar.

The flywheel will loosen then lift it off. See Figure 8.5.

NOTE: If replacing a short block, exchange the crankcase

and cylinder with the short block and follow the

previous steps in reverse order.

9. Remove the muffler using a T-27 torx driver or a 5/

16” wrench. See Figure 8.6.

Figure 8.4

Screws

Figure 8.5

Never hit the

crank shaft with

a hammer!

use a brass punch

! CAUTION! CAUTION

Never strike the crankshaft

directly with a hammer. To pre-

vent damage to the crankshaft

use a brass punch or a piece of wood

between the hammer and the crankshaft.

Figure 8.6

Muffler screws

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63 64

Sem comentários

MTD 25cc Especificações Página 57